Remote Valve Controls

TEE HANDLE REMOTE CONTROL UNITS

Push-pull control for the operation of in-line, quarter turn ball valves or built-in eductors. Handle configuration allows identification/location label to be inserted.

RC-10 – SLOW CLOSING VALVE CONTROL

• Remote actuation of any ball valve.
• Linear output screw-type actuator compliant with NFPA 1901 (as it pertains to slow-closing valves)
• Actuator and push-rod constructed of extruded aluminum alloys.
• Precision needle thrust bearing and hardened thrust washers.
• 5” cast alloy hand-wheel with collet-type connection allows for easy compact thru-panel installation (either new or retro-fit).
• Furnished with threaded ball swivel joint at end of drive rod.
• Installation diameter: 1.03” (pump panel)
• Length: 16.4” (retracted) and 21.4” (extended)
• Weight: 3.2 lbs.
• Valve Status Indicator (optional)

VALVE STATUS INDICATOR

• Requires minimal pump panel space.
• Tri-color indicators: red (closed), yellow (gated) and green (open).
• Feature 100,000 hour ultra bright LEDs mounted within an optical filter to maximize visibility in bright sunlight.
• NEMA 4 rated.
• Chrome bezel included.

775-5 – HANDLE

• For remote control screw type gate valve or gear driven valve.
• Bored for .375” rod.
• Material: Cast brass with chrome-plated finish.
• Diameter: 4”.
• Weight: 1.0 lbs.

775-11 – ROD GUIDE

• For centering and guiding remote control rod.
• Nylon sleeve for 0.5” rod.
• Material: Cast brass with chrome-plated finish.
• Diameter: 1.5”.
• Weight: 0.2 lbs.

775-15 – TEE HANDLE

• For use with push-pull rods to remotely operate in-line, quarter turn ball valves or built-in eductors.
• Bored for 0.5” rod.
• Can be threaded to .500” — 13 or .500” — 20 (specify).
• Handle configuration allows identification/location label to be inserted.
• Material: Cast brass with chrome-plated finish.
• Height: 1.1”
• Weight: 0.5 lbs.

POSITION INDICATING

DIRECT MOUNT

PANEL MOUNT